Main page » SOFTAIL » Mirrors, handlebars and cables » Handlebar

Handlebar

Stylish, 30mm diameter model-specific handlebars that give you a comfy sitting position. The "Reduced Reach" version provides a higher inclination towards the driver. Bars are drilled for internal wiring.

from 0,00 EUR

incl. 19% tax excl. Shipping costs

PERFORMANCE MACHINE THREE-PIECE T-BARS

Aluminum handlebar in 1 1/4" (32mm) diameter, tapered to 1" at the handlebar control side. Comes complete with billet aluminum risers and top handlebar clamp that fits on Harley-Davidson models with telescopic front forks and regular 3 1/2" on-center riser mounts. These handlebars are ready for use with Throttle-By-Wire electronic throttle and also work with regular cable throttle. They feature PM's proprietary texture two-tone OPS finish.

from 0,00 EUR

incl. 19% tax excl. Shipping costs

AMERICAN MADE 1 1/4” DIAMETER PHAT T-BAR HANDLEBARS

These USA made bars have the ultimate style, great comfort and quality. At 1 1/4" (3.2cm) diameter, they are 25% thicker than stock, and eliminate the wimpy look of the standard 1" (2. 54cm) handlebars. The "step down" design fits all standard or aftermarket controls and grips. T-Bars take 1/2"-13 UNC riser bolts.

from 0,00 EUR

incl. 19% tax excl. Shipping costs

ZODIAC'S "FAT BUBBA" T-BAR HANDLEBAR

The name of these handlebars says it all. These 1 1/4" (32mm) diameter bars will give your bike a great massive look and will fit the standard or aftermarket controls and grips. T-Bars bolt straight onto the upper fork clamp of most Harley models with a 3 1/2" (88.9mm) center-to-center. These handlebars are dimpled and drilled for internal wiring and are not suitable for Throttle-By-Wire.

from 0,00 EUR

incl. 19% tax excl. Shipping costs

ZODIAC CLUBSTYLE CHUBBY BARS

These handlebars are 1 1/4" (32mm) in diameter with 1" (25.4mm) ends to accept stock controls. Bars are dimpled and pre-drilled to accept internal wiring.

from 0,00 EUR

incl. 19% tax excl. Shipping costs

BURLY FAT FOLSOM T-BARS

These handlebars are 1 1/4" (32mm) in diameter with 1" (25.4mm) ends to accept stock controls. Bars are dimpled and pre-drilled to accept internal wiring.